The application of activated carbon for the adsorption and elution of platinum group metals from dilute cyanide leach solutions
Date
2013
Journal Title
Journal ISSN
Volume Title
Publisher
Southern African Institute of Mining and Metallurgy
Abstract
ENGLISH ABSTRACT: The research presented in this paper investigated the practical aspects of the recovery of platinum group metals (PGMs) from a dilute cyanide leach solution containing base metals, in a manner similar to that used for gold extraction in a typical CIP process, and focuses on both the adsorption and elution stages. The carrierphase extraction of precious metals using activated carbon offers significant advantages over other processes in terms of simplicity, the high pre-concentration factor, rapid phase separation, and relatively low capital and operating costs. As a sorbent, activated carbon is still by far the most important material because of its large surface area, high adsorption capacity, porous structure, negligible
environmental toxicity, low cost, and high purity standards.
Adsorption tests were conducted on a pregnant alkaline leach
solution (0.15 ppm Pt, 0.38 ppm Pd, 0.1 ppm Au) resulting from cyanide extraction performed in column leach tests. The initial adsorption rates of Pt, Pd, and Au were very fast and recoveries of these three metals were approximately 90 per cent after 2 hours, and 100 per cent for Pt, 97.4 per cent for Pd, and 99.9 per cent for Au after 72 hours. The parameters that influence the extraction of PGMs and Au were examined to assess their relative importance during the adsorption process in order to provide the basis for process optimization. The concentration of thiocyanate was not identified as significant factor for PGMs adsorption, while Ni concentration was the most significant extraction process parameter. Base metal cyanide complexes adsorb and compete with the PGM complexes for sites on activated carbon, and while copper
adsorption can be minimized by adjusting the residence time, Ni adsorbs at approximately the same rate as the PGMs, influencing the loading capacity and adsorption kinetics of the PGMs. The feasibility of eluting platinum and palladium cyanide complexes from activated carbon using an analogue of the AARL process was investigated. Platinum and palladium elute from activated carbon almost to completion in 4 to 5 bed volumes at 80°C, while the elution of gold at this temperature is slow, with a significant amount of gold still to be eluted after 16 bed volumes. The equilibrium loading of gold is exothermic in nature (Fleming and Nicol, 1984) which will result in an increase in gold elution kinetics with an increase in temperature at similar pre-treatment conditions. A similar result was found for the elution of Pt and Pd.
Cyanide pre-treatment was found to have a significant influence on PGM elution. Higher cyanide concentration in the pre-treatment step results in more efficient elution up to a point, and results suggest the possibility of an optimum cyanide concentration, beyond which elution efficiency starts decreasing due to increased ionic strength.
Description
CITATION: Snyders, C. A. et al. 2013. The application of activated carbon for the adsorption and elution of platinum group metals from dilute cyanide leach solutions. Journal of the Southern African Institute of Mining and Metallurgy, 113(5):381-388.
The original publication is available at https://www.saimm.co.za
The original publication is available at https://www.saimm.co.za
Keywords
Carbon -- Absorption and adsorption, PGMs (Platinum group metals), Cyanic acid -- Leaching
Citation
Snyders, C. A. et al. 2013. The application of activated carbon for the adsorption and elution of platinum group metals from dilute cyanide leach solutions. Journal of the Southern African Institute of Mining and Metallurgy, 113(5):381-388.